您的位置:网站首页 > 制钉机

使用射钉枪时的注意事项

作者:管理员 来源:未知 日期:2012/4/17 9:57:40 人气: 标签:
导读:装好射钉弹后,严禁用手直接推压钉管。不要把装好射钉弹的射钉器对准他人。射击过程中,如遇射钉弹不发火,应静停5秒钟以上,制钉机才能移动射钉器。在射钉器使用…

装好射钉弹后,严禁用手直接推压钉管。不要把装好射钉弹的射钉器对准他人。射击过程中,如遇射钉弹不发火,应静停 5 秒钟以上,制钉机才能移动射钉器。在射钉器使用结束,或维修、保养前均应先取出射钉弹。
对软质( 如木质 )被固件或基体射击,选择射钉弹威力要适当,威力过大,将会打断活塞杆。射钉器使用时间长了,应及时更换易损件(如活塞环 ),否则射击效果不理想(比如威力下降 )。
射击完后,应及时擦拭或清洗射钉器各零部件。各种射钉器均有说明书,使用前应阅读说明书,了解该射钉器的原理、性能、结构、拆卸和装配方法,遵守规定的注意事项。(图/文
www.zhidingjixie.com
中译英:
Installed after nailing shells, prohibit the use of direct hand push pin tube. Don't put nail bomb nailer at someone else. The shooting process, such as the case of nailing shells misfired, stop 5seconds or more should be static, can move the nailer. The nailing device used at the end of, or repair, maintenance should be removed before the first nail bomb.

On the soft (such as wood ) is a firmware or matrix shooting, choose appropriate nail bullet power, power is too large, will interrupt the piston rod. Nailing device used for a long time, the timely replacement of wearing parts (such as a piston ring ), or shooting effect is not ideal ( such as power down).

本文网址:
上一篇:射钉器的简述
共有:条评论信息评论信息
发表评论
姓 名:
验证码: